字體:小 中 大 | |
|
|
2017/08/18 17:38:17瀏覽67|回應0|推薦0 | |
Xhorse VVDI2 Key Programmer newly add BMW FEM/BDC Key Learn function, this function is optional. Here let’s simply know about Xhorse VVDI2 BMW FEM/BDC Key Programming function. Users can refer to following information (3 steps for make keys:get key info->programming FEM/BDC system->make keys)
Notes: 2.add keys, reset KM, erase key must programming FEM/BDC system first 3.in FEM/BDC interface, if ‘get key info’ the type not support, it will show:customer should use “BMW E-sys software” program FEM/BDC system.then programming FEM/BDC system with VVDI2-BMW 4.when operation on ‘programming FEM/BDC system’interface,please don’t close this software window until all procedures completed. 5.programming FEM/BDC system, require soldering and get eeprom.(FEM 95128 chip, BDC 95256 chip)usually there are 2 same chips on the module, please refer to the software diagram, select the correct one. 6.programming FEM/BDC system,must restore the original eeprom, restore coding.if cannot restore coding or after restore coding assemble FEM/BDC module back to car,but with problem(such as the remote control cannot start the car 7.if connect power to FEM/BDC module, but the relay keep ringing,please contact technical support for help.usually operation on FEM/BDC should be ok,just need to programming. More information, please check on:http://www.fobdii.com/wholesale-507-vvdi2-key-programmer.html |
|
( 知識學習|其他 ) |