字體:小 中 大 | |
|
|
2007/05/07 00:53:30瀏覽1613|回應0|推薦6 | |
Module 3: EIGRP Which router command will enable IGRP with an autonomous system number of 100? router(config)# igrp 100 Which Layer 4 protocol does EIGRP use to provide reliability for the transmission of routing information? DUAL Why would it be necessary to configure the bandwidth setting on an EIGRP interface rather than leaving it at the default setting? (Choose two.) A suboptimal route may be chosen as the best path to a destination if the bandwidth setting is higher than the actual bandwidth of the link. Which of the following router commands is recommended only for troubleshooting specific types of network problems, not for monitoring normal network operation? show Which of the following are found in the EIGRP neighbor table? (Choose two.) routes installed by DUAL Which command will display only the current EIGRP routing table entries? Router# show ip route A technician has accidentally disconnected an Ethernet cable from a router to a network that is advertised by IGRP. IGRP has issued a triggered update alerting other routers in the enterprise that the network is unreachable. What is the minimum amount of time that will elapse before the other routers will be able to use this network after it is reconnected, assuming default timer settings? 200 seconds Which of the following statements are true of routers that are running EIGRP? (Choose three.) They can support multiple routed protocols. What type of command will allow an administrator to check normal router behavior? show commands A LAN has been found to be unreachable in an enterprise network that is routing IGRP. Which commands can be used to check the IGRP configuration of the router attached to the unreachable network? (Choose three.) router# debug igrp In which of the following tables does the EIGRP DUAL algorithm store the primary route to a destination? (Choose two.) routing Which command will help identify established OSPF neighbor adjacencies? router# show ospf neighbor What tables does EIGRP maintain for each routed protocol it supports? (Choose three.) adjacency table Host 192.168. R1(config-router)# network 192.168.1.128 One part of the network shown in the graphic uses IGRP and another part uses EIGRP. Which of the following statements are true about this network? (Choose two.) IP traffic will not be routable from network 192.168.1.0 to network What information is maintained in the EIGRP topology database for a destination route? (Choose three.) the routing protocol What is the default administrative distance of EIGRP internal routes? 70 What is the EIGRP term for a backup route? backup route Which of the following types of routes will be denoted by EX in EIGRP routing table entries? (Choose two.) routes learned from other routing protocols Which router command can be used to identify traffic bottlenecks or locate broken network connections on the path to a destination? telnet Which of the following statements describes the bounded updates used by EIGRP? Bounded updates are sent to all routers within an autonomous system. What is the advantage of routers forming adjacencies when using EIGRP? (Choose three.) Neighbor routers can quickly take over for a router that is in passive mode. What must be configured for IGRP and EIGRP to automatically share and redistribute information? identical maximum hop limits |
|
( 休閒生活|網路生活 ) |