Xtool X100 PAD2 Battery Drain and Power off Final Solution

Problem:

Hello, I recently purchased the XTOOL X100 Pad2 tablet key programmer and I am delighted. But I think I have a battery problem. I left it fully charged and 1 day later I tried to use it and it was dead. I also noticed that the battery drains very quickly when in use, going from 100% to 60% in about 15 minutes. What can I do against it? Is it possible for you to repair or replace it?

Final Solution to Xtool X100 PAD II Battery Drains and Power off problem from Xtooltech engineer:

Tools required:

1pc* Static bracelet

1pc* Hot air gun  (350±10℃ Temperature setup: 350±10℃)

Precautions: Please wear the static bracelet before each operation.

Procedure 1:  Change C6 capacitor

Position: C6

Name: Chip capacitor

Chip specification: 4.7UF/10V  0603

1.Disassemble the C6 capacitor and desolder a 4.7K 0603 resistor.

Procedure 2: Remove transistor

Position: Q14

Name: S8050

Chip specification:  0.1uF/50V 0402

1.Disassemble the Q14 transistor.

Procedure 3: Change C123 capacitor

Position: C123

Name: Chip capacitors

Chip specification:  0.1uF/50V 0402

1.Replace the C123 capacitor with a 3.3K  0402 resistor.