字體：小 中 大 |
|
|
|
| 2020/08/14 15:21:46瀏覽74｜回應0｜推薦0 | |
| In any process plant, the gate valve contains the most common use and therefore are suitable for both above-ground and underground installations. A gate valve at stvvalves.com is usually known as a sluice valve. It is very all to easy to open it, one just need to lift the gate out on the path on the fluid. It does not demand a wide surface; they fit in a very little space over the pipe axis. It requires a 360° surface contact between disk and seat to obtain proper sealing.
A Gate valve consist of certain parts that permit it to work properly. Valve’s body or shell is regarded as the principal much of this particular valve which could connect inlet and outlet pipes in a very piping system. Some other elements of a gate valve are as followed. Bonnet, Solid Wedge, Body seats, Stem, Back seat, Gland follower, Gland flange, Stem Nut, Yoke Nut, Handwheel, Hand wheel nut, Stud bolts, Nuts, Bonnet Gasket, Lubricator, Packing. All these parts let the Gate & sluice valve to perform properly. Slab gate valves are comprised of a single gate unit which raises and lowers between two seat rings. Due for the fact that this gate slides between seats, slab gate valves are suited to the medium with suspended particles. The sealing surface of slab gate valves is virtually self-positioned and is not damaged from the thermal deformation from the body. Even if the valve is closed in the cold state, hot elongation in the stem doesnt overload the sealing surface, and slab gate valves without diversion holes will not require high precision within the closing position in the gate. When the valve is fully open, the bore through is smooth and linear, the flow resistance coefficient is minimal, piggable no pressure loss. It is really a shut-off valve with throttling capacity. It is intended more for material flow about flow regulation. More suited to thicker flow media, the flat disc of gate valves makes it easier to chop through such sort of media. The working of the gate valve is pretty simple. When the gate on the valve is lifted in the flow path, the valve opens and in the event the gate again returns to its position, the gate valve closes. This gate movement is achieved by manually turning the hand-wheel. The hand-wheel rotates the valve stem as well as the internal threaded mechanism comes with a vertical movement on the gate. As the hand-wheel is turned several full cycle absolutely open or fully close the gate valve, also, they are known as multi-turn valves. Electrically actuated gate valves are offered but not cost-effective. Finally, you will need to know how the valve will likely be integrated into the system plus the type of assembly or installation used, particularly if it needs to be welded, bolted through flanges or screwed in. |
|
| ( 休閒生活｜其他 ) |
