字體:小 中 大 | |
|
|
2016/03/21 17:22:01瀏覽1280|回應0|推薦0 | |
Mercedes-Benz diagnosis DAS comes with initialization fault (1.1)-1.501.9551. Here, mbstartool technicians offers some useful solutions to try. Tool used with: MB STAR C3/ SDconnect C4/ SD C5 CONNECT multiplexer (here is the case with SD C5)
Models: Mercedes-Bnez W208 ’2003
Error message: Die Initialisierung des Multiplexers ist fehlgeschlagen (The initialization of the multiplexer failed) BMP: Fault (1.1)-1.501.9551 Initialization of diagnosis multiplexer failed Possible cause: The link between this diagnosis multiplexer and the diagnostic socket is interrupted The link between the diagnosis multiplexer and the diagnostic unit is interrupted The voltage supply at the diagnostic socket (circuit 30 and (or) circuit 31) is faulty Note: When using SDconnect, check the connection status using the Toolkit
Analysis from technician :
pay attention to the icon in the bottom right corner When the computer starts, connect to the Device 21(SDconnect multiplexer) The cross “x” there means bad communication or some other causes
Optional solutions for bad communication: 1- cable problem 1) the cable from the car to the mux you may replace it if the mux is not light on Go to Local Network Connection Plug and unplug the SD C5 com port for times to see if there is change in Local Network Connection or not. If not, change another computer to try again, also in this way. But, if still not any change in any computer, you may replace the LAN cable with another one to have a try.
2- mux problem If you still have the same problem, it means that the mux is not ok
But if unluckily with all solutions before, please send back your unit to the vendor for repairing. http://blog.mbstartool.com/2016/03/19/how-to-solve-das-initialization-fault-1-1-1-501-9551/ |
|
( 創作|另類創作 ) |