EZVIZ  C2C

Setup

Step 1 Power-on Plug the power cable into the camera and

to the power adapter and then into a power outlet, as shown in the figure below.

The LED indicator will flash red and blue when the camera is ready for setup

Step 2 Camera

Setup 1. Create an user account - Connect your mobile phone to Wi-Fi.

- Download and install the EZVIZ app by searching

  “EZVIZ” in App Store and Google PlayTM.

- Launch the app and register for an EZVIZ user account following the start-up wizard.

2. Add a camera to EZVIZ   EZVIZ

- Log in the EZVIZ app.

- From the EZVIZ app Home screen, tap “+”

on the upper-right hand corner to go to the scan QR code interface.

- Scan the QR Code on the bottom of the camera.

- Enter the verification code located on the bottom of the camera.

- Enter the correct time zone and DST information and tap “Finish” to finish setup.

3. Changing the default password After adding the camera,

you are required to change the device password to ensure your video security.

The password is used for the Image Encryption.

If you turn on the Image Encryption, you are required to

input your password when you live view or play back the camera.

- Go to the camera settings screen to change the default password.

- Tap on “Change Password”

- Tap on “Edit”.

- Enter the original verification code located on the bottom of the camera.

- Enter the new password.

  Please use letters and numbers between 6 to 12 characters.

Installation Step 1 Installing the Metal Plate (Optional)

Pick a clean and flat surface and secure the metal plate to

the desired position with the foam stickers or screws (not included).

There’s a magnet piece inside the camera.

You can skip this step if the surface is made of metal

Step 2 Installing the Camera

Secure the camera magnetically to the metal plate or metal surface (see figure below).

Step 3 Completing Installation

Adjust the camera angle as required

Appendix

Basics

Box Content

Installing Memory Card

Insert a microSD card into the slot until a click.

Initializing Memory Card

1. In the EZVIZ app,

check the memory card status

by tapping on the Storage Status in the Device Settings interface.

2. If the memory card status displays as Uninitialized, tap to initialize it.

The status will then change to Normal.

You can then start recording any event triggered video

in the camera such as motion detection.